Important Information

The OdaLog L2 was designed specifically for the wastewater industry, based on valuable input and feedback from plants, equipment and chemical suppliers and industry consultants Typical applications include locating and monitoring the source of Hydrogen Sulfide gas emissions at pump and lift stations, collection systems, and receiving manholes. Once the source of the odor is determined, the OdaLog L2 can be used to prove the effectiveness of hydrogen sulfide reduction strategies that have been implemented. OdaLog customers cost-justify instruments through chemical savings realized by determining the specific times that the H2S emissions occur.

The OdaLog L2 is small, robust, and capable of extensive data logging. Double O-rings minimize moisture ingress and water damage to the instrument’s electronics. Magnetic switches for zeroing and calibrating and an infrared communications link eliminate outside pin connections and associated corrosion problems. The OdaStat-G Software is used for programming the L2 OdaLog, as well as for downloading the data after completing a logging session. The L2 uses a single lithium battery that lasts up to 12 months, has increased memory capacity, uses a single screw design for simple and effective assembly/disassembly and uses IrDA communication protocol for faster downloading.

Four different detection ranges are available:

• 0 – 50 PPM(part number SL-H2S-50)
• 0 – 200 PPM(part number SL-H2S-200)
• 0 – 1000 PPM(part number SL-H2S-1000)
• 0-2000 PPM(part number SL-H2S-2000)

The L2 is also available with a Long Term sensor, which allows for longer deployment times, (up to thirty days at a time). Two ranges are available:

• 0 – 200 PPM(part number LL-H2S-200)
• 0 – 1000 PPM(part number LL-H2S-1000)